Makita BL1014 10.8V Lithium-Ion 1.5Ah

The Makita BL1014 10.8V (12V max) 1.5Ah is a compact, slide-style lithium‑ion battery designed for Makita CXT tools. It prioritizes light weight and balance for precision tasks, quick service calls, and overhead work.

Key specs

Voltage	10.8V nominal (12V max)
Capacity	1.5Ah (≈16 Wh)
Typical charge time	≈50 minutes on standard CXT charger; faster on rapid chargers
Battery style	Slide-style CXT (compact)
Protection	Electronics to help prevent overload, over‑discharge, and overheating (with compatible tools/chargers)

When to choose this battery

• Use if you prioritize low weight and tool balance for trim, cabinetry, punch-list tasks, and tight spaces.
• Use as a budget-friendly spare to rotate on the charger for continuous light-duty work.
• Avoid if you routinely drill large holes, drive long structural screws, or cut dense materials—choose a higher‑capacity CXT pack instead (e.g., 2.0Ah or 4.0Ah).

Compatibility

• Works with Makita 10.8V/12V max CXT slide‑style tools and CXT chargers.
• Not compatible with Makita 18V LXT tools or older 10.8V pod‑style tools/batteries.
• For best performance and battery health, pair with Makita tools/chargers that support Star Protection.

Charging

• Standard CXT charger: about 50 minutes from empty to full (conditions may vary).
• Rapid CXT charger: typically faster, around 30–40 minutes.
• Best practice: rotate two batteries to keep one on the tool and one on the charger.

Expected runtime (approximate)

With about 16 Wh of energy, this pack suits light-duty, intermittent use. Real-world results vary by tool, material, and technique, but as planning guidance:

• Driving 1–1/4 in wood screws in softwood: roughly 80–150 screws per charge.
• Drilling 3/16 in holes in pine: roughly 40–80 holes per charge.
• Light trim fastening or electrical service work: several short tasks between charges.

Care and safety

• Store at 40–60% charge in a cool, dry place; avoid extreme heat and direct sun.
• Operate/charge within typical Li‑ion ranges (about 32–104°F / 0–40°C for charging).
• Avoid deep discharges; recharge when you notice power drop‑off.
• Keep contacts clean and dry; wipe with a soft, dry cloth as needed.
• Do not use damaged packs; recycle according to local e‑waste guidelines.

Alternatives in the CXT line

• BL1021B (2.0Ah): ~33% more runtime with a small weight increase—good daily driver.
• BL1041B (4.0Ah): Maximum runtime for heavier or continuous use; noticeably heavier and bulkier.

FAQ

Is 10.8V the same as 12V max?

Yes. 10.8V is the nominal voltage of a three‑cell Li‑ion pack; 12V max is the peak rating. Makita’s CXT tools use this platform.

Will the BL1014 fit my tool?

It fits Makita 10.8V/12V max CXT slide‑style tools. It does not fit 18V LXT tools or older 10.8V pod‑style tools.

Can I leave the battery on the charger?

Makita chargers manage charging and typically switch to maintenance once full. For long‑term storage, remove and store the battery partially charged in a cool, dry place.

How can I extend battery life?

Avoid full depletion, keep within recommended temperature ranges, and rotate multiple packs to reduce heat buildup.

What jobs is this 1.5Ah pack best for?

Light fastening, pilot holes in softwood, trim and cabinet work, and service calls where compact size and low weight matter.